07-24-2013 07:51 AM - edited 03-04-2019 08:32 PM
Until you have single WAN, the problem doesn't exist;
but when you have to configure multiple WANs, born the issue.
In specific I'm speaking about the CISCO888-EA-K9.
System image file is "flash:c800-universalk9-mz.SPA.153-2.T.bin"
Normally you can add a controller SHDSL 0 or SHDSL 0/0/0 (although the ios onboard doesn't support the last sintax);
I have a conf the shows how another 888 is configured with SHDSL 0/0/0 + SHDSL 0/1/0, but I can't do the same with SHDSL 0 + SHDSL 0.1
Router(config)#controller shDSL 0.1
^
% Invalid input detected at '^' marker.
Router(config)#controller shDSL 0/1/0
^
% Invalid input detected at '^' marker.
Where is my error?
Thanks for your support.
07-24-2013 08:21 AM
I don't see how you can add another controller or interface. 880 routers are fixed configuration.
07-24-2013 08:34 AM
Salve Paolo,
mi sono fato inoltrare una running-config da Wind (Provider in questione), che mostra:
!
multilink bundle-name authenticated
license udi pid C888EA-K9 sn xxx
license boot module c800 level advipservices
!
!
!
!
!
!
!
controller SHDSL 0/0/0
mode efm
dsl-group 0 pairs 0
!
!
!
controller SHDSL 0/1/0
mode efm
dsl-group 0 pairs 0
!
!
!
!
interface Ethernet0/0/0
description 2Mb shdsl ULL xxx
no ip address
no shut
!
interface Ethernet0/0/0.3909
description efm
encapsulation dot1Q 3909
ip address x.x.x.x 255.255.255.252
!
!
!
interface Ethernet0/1/0
description 2Mb shdsl ULL xxx
no ip address
no shut
!
interface Ethernet0/1/0.3406
description efm
encapsulation dot1Q 3406
ip address x.x.x.x 255.255.255.252
!
!
interface Vlan1
ip address x.x.x.x 255.255.255.248
ip virtual-reassembly in
!
07-24-2013 10:49 AM
That config is not from an 880 router.
You need to use controller and interface numbers as your router have.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide