Display SFP light level on a ISR 1100

[schwarzenbachcyb]

Is there a command to see the Rx/Tx light levels from the SFP on a ISR1111-4P?

There is no "sh int gi 0/0/0 transceiver" command

isr1100#show int gi 0/0/0 trans?
% Unrecognized command
isr1100#sh int gi 0/0/0 trans   
                                 ^
% Invalid input detected at '^' marker.

running 16.09.02.

The SFP that is plugged in is supporting DOM.

[Mark Malone · Accepted solution]

Hi
try something like this below , check show inventory first for the sub slot

sh hw-module subslot 0/0 transceiver 0 idprom

[schwarzenbachcyb]

Thank you very match. The command is "show hw-module subslot 0/0 transceiver 0 status"

ISR1100#show hw-module subslot 0/0 transceiver 0 status
The Transceiver in slot 0 subslot 0 port 0 is enabled.
  Module temperature                        = +41.605 C
  Transceiver Tx supply voltage             = 3288.9 mVolts
  Transceiver Tx bias current               = 21828 uAmps
  Transceiver Tx power                      = -6.3 dBm
  Transceiver Rx optical power              = -9.4 dBm

[Mark Malone]

ah great wasn't to far off :)