Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I need to know, if I can create a layer2 bridge-domain and apply them to multiple router ports on a Cat8300 (running in the IOS-XE mode). For example something like this:
interface bdi 100
ip address 10.10.10.1 255.255.255.0
interface giga...
Hi all
I would load to add a specific configuration from a txt-file to a running Cisco Nexus 3600/9000 switch. Not overwriting the whole current configuration, but add the configuration from the configuration file.
For example, I have a running nexus...
Hi DMVPN Pros
Maybe a DMVPN hero can help me out. I have a DMVPN setup with multiple spokes that are behind the same CGN (mobile 4G network). So there is a possibility that 2 CPEs may have the same public IP address after processing the CGN.
Is this ...
Hi all I have a few ASR920 in my network and have noticed several times that an IOS file download to the local flash is extremely slow. It doesn't matter if the ASR920 is connected to a 100Mbit or 10G link and if the source is FTP or SCP.For the down...
Thank you for the document. The document describes the
Spoke-to-Spoke
Tunnels. What I like to know is, if the
Spoke-to-Hub
tunnels will also have problems, if two Spokes are translated to the same public IP address.
Maybe CoPP is what you are looking for? "The CoPP feature improves security on your device by protecting the CPU from unnecessary traffic and denial of service (DoS) attacks. It can also protect control traffic and management traffic from traffic dro...