06-16-2014 08:36 AM - edited 03-04-2019 11:09 PM
Hi,
I am looking for a simple configuration for a dmvpn network running eigrp with two hubs on a single cloud.
Do i just create two nhs entries, nhrp map entries, and two multicast entries on the spoke router tunnel interfaces? And on the hub routers add a delay on the tunnel interfaces for the one i prefer to be the secondary?
I am looking for confirmation and any other tweaks i need to make. i cant seem to find any examples.
Thanks in advance!!
06-16-2014 09:03 AM
Hello
Try here -
Dual DMVPN
res
Paul
06-16-2014 10:08 AM
Thanks Paul, I have looked over this design guide as this was the fist place i went. however, i cannot find a configuration example for dual hub/single cloud.
i see the high level design and know you can do it. but it doesnt show what the configuration would look like...unless i am just reading over it.
Thanks
11-08-2014 03:54 PM
Hello Chuckholley, did you ever find a configuration example for a dmvpn network running eigrp with two hubs on a single cloud? I am getting ready to deploy this type of configuration and have not found any examples. The DMVPN design guide shows a diagram of this type of network but no configuration examples. I think I am just going to test this is my lab and see how it works out.
05-13-2015 09:42 AM
I know this is an old thread ....
but did anyone have any joy with a config examples?
i have found some bits and pieces nothing nice and tidy. ideally looking for dual hubs with single clound.
Thanks
Mark
05-13-2015 07:38 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide