Hello everyone, I created two vrf on my spoke router to switch main and backup ISP, everything works fine, but I have 2 dmvpn peers instead 1.
sh dmvpn
Legend: Attrb --> S - Static, D - Dynamic, I - Incomplete
N - NATed, L - Local, X - No Socket
# Ent --> Number of NHRP entries with same NBMA peer
NHS Status: E --> Expecting Replies, R --> Responding, W --> Waiting
UpDn Time --> Up or Down Time for a Tunnel
==========================================================================
Interface: Tunnel0, IPv4 NHRP Details
Type:Spoke, NHRP Peers:2,
# Ent Peer NBMA Addr Peer Tunnel Add State UpDn Tm Attrb
----- --------------- --------------- ----- -------- -----
1 x.x.x.3 10.1.1.2 UP 00:06:15 S (this is right peer)
1 y.y.y.y 10.1.1.35 UP 00:05:32 DX (wrong)
Interface: Tunnel1, IPv4 NHRP Details
Type:Spoke, NHRP Peers:2,
# Ent Peer NBMA Addr Peer Tunnel Add State UpDn Tm Attrb
----- --------------- --------------- ----- -------- -----
1 x.x.x.4 10.1.2.2 UP 00:11:38 S (this is right peer)
1 a.a.a.a 10.1.2.35 UP 00:11:36 DX (wrong)
interface Tunnel0
ip address 10.1.1.62 255.255.255.0
no ip redirects
ip mtu 1400
ip nhrp authentication <key>
ip nhrp map 10.1.1.2 x.x.x.3
ip nhrp map multicast x.x.x.3
ip nhrp network-id <id>
ip nhrp nhs 10.1.1.2
ip nhrp registration no-unique
ip nhrp shortcut
ip nhrp redirect
load-interval 30
delay 10
if-state nhrp
tunnel source Vlan5 (for ISP 1)
tunnel mode gre multipoint
tunnel key <key>
tunnel vrf INET1
tunnel protection ipsec profile profile-DMVPN
interface Tunnel1
ip address 10.1.2.62 255.255.255.0
no ip redirects
ip nhrp authentication <key>
ip nhrp map 10.1.2.2 x.x.x.4
ip nhrp map multicast x.x.x..4
ip nhrp network-id 21
ip nhrp nhs 10.1.2.2
ip nhrp registration no-unique
load-interval 30
delay 5000
tunnel source Dialer0 (ISP 2)
tunnel mode gre multipoint
tunnel key <key>
tunnel vrf INET2
tunnel protection ipsec profile profile-DMVPN
My Tunnels looking for 10.1.1.2 and 10.1.2.2
but why I have also peer to 10.1.1.35??
