Don't configure the speed 100M in Catalyst 8300 uses GLC-TE

[hui-zhao]

hi,  

   I am configuring the Catalyst 8300 and install the sfp module GLC-TE in interface G0/0/4. but i don't configure the speed 100M in this interface, how can I configure to 

[M02@rt37]

Hello @hui-zhao 

Regarding the matrix compatibility, you need IOS XR 17.3.2 

https://tmgmatrix.cisco.com/?npf=1042

On interface Gi0/0/4, configure speed command.

[hui-zhao]

no speed command in this interface. 

[M02@rt37]

What about IOS version ?

[hui-zhao]

17.9.6

[M02@rt37 · Accepted solution]

Ok @hui-zhao 

I think you will need C-NIM-2T card to have 100Mbits/s compatiblilty.

The C-NIM-2T is a dual combo port module with two RJ-45 copper line ports and two SFP fiber ports. The ports on this NIM are configured in two port groups with one RJ45 port and one SFP port in each group. One port from each group can be configured for simultaneous use, providing flexibility in the selection of media for WAN connectivity. The RJ-45 ports support 100BASE-TX and 1000BASE-T copper connections. The SFP ports support 100BASE-FX and 1000BASE-X fiber connections. The module supports 256-bit WAN MACsec. The C-NIM-2T is supported on the Catalyst 8200 Series, 8200L, and all 8300 Series platforms.

--https://www.cisco.com/c/en/us/products/collateral/routers/catalyst-8300-series-edge-platforms/catalyst-8000-gigabit-ethernet-wan-modules-ds.html

[hui-zhao]

rouer model: C8300-1N1S-6T

[Leo Laohoo]

GLC-T/TE will only operate in 1 Gbps.

[hui-zhao]

But I use the GLC-T/TE on ISR 4000 series router, can be configured the speed to 100Mbps. Your mean that on C8200/8300 series router, only can be operated in 1 Gbps？