Hi there! I'm currently trying to setup Dynamic DNS for a home server I'm running so I can update multiple subdomains on it. Unfortunatly after trying multiple way of configuring it I get a Bad parameters error when Debugging is enabled. I have a Cisco 3825 connected to a switch I got to help me learn IOS as I'm working to get a CCNA (I found one for a smoking deal!). However for the life of me I just cannot figure this out. When trying to figure it out I've changed the host= to mc, mcadmin, resrise, and <h> without it working thus far.
Debug shows the following:
*Feb 7 07:23:51.231: DYNDNSUPD: Adding DNS mapping for resrise.manate.ch <=> [External IP] server 126.96.36.199
*Feb 7 07:23:51.231: HTTPDNS: Update add called for resrise.manate.ch <=> [External IP]
*Feb 7 07:23:51.231: HTTPDNSUPD: Session ID = 0x2E
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...