04-13-2021 03:19 PM - last edited on 04-13-2021 05:59 PM by Jimena Saez
In this event we will answer all your questions related to dynamic routing protocols with IPv6 configuration, verification, troubleshooting, and general best current practices. All questions regarding design, in-depth mechanics, and features of the Routing Information Protocol for IPv6, OSPFv3, ISIS, EIGRPv6, and BGP are welcome.
To participate in this event, please use the button below to ask your questions
Ask questions from Wednesday, April 14 to Tuesday, April 27, 2021
04-20-2021 02:02 PM
6PE and 6VPE allow us to run IPv6 over an IPv4-only MPLS core where we use dual stack PE routers.
This allows service providers to offer IPv6 to their customers without making major changes to the core of their MPLS network.
The main difference between 6PE and 6VPE will be:
Senior Technical Consulting Engineer
04-20-2021 02:22 PM
Both 6PE and 6VPE transport IPv6 traffic over the MPLS core. The MPLS core does not need to be running IPv6 at all (except for the PE). IPv6 traffic will be encapsulated in an MPLS LSP and forwarded to the relevant egress PE.
The difference between the two is that 6PE works using the global routing table on the PE, whereas 6VPE will perform the IPv6 lookup from a VRF routing table on the PE. So 6VPE is equivalent to IPv4 L3VPN.
04-21-2021 09:12 AM
What are the OSPFv3 LSA types?
04-21-2021 09:50 AM
Much of OSPF version 3 is the same as in OSPF version 2. OSPFv3, which is described in RFC 5340, expands on OSPF version 2 to provide support for IPv6 routing prefixes and the larger size of IPv6 addresses.
Here are the OSPFv3 LSA types.
The following list describes LSA types, each of which has a different purpose:
04-23-2021 11:20 AM
How do you configure RIP for IPv6?
04-23-2021 11:34 AM - edited 04-23-2021 11:35 AM
IPv6 RIP works the same and offers the same benefits as RIP in IPv4. RIP enhancements for IPv6, detailed in RFC 2080, include support for IPv6 addresses and prefixes, and the use of the all-RIP-devices multicast group address FF02::9 as the destination address.
- Make sure Ipv6 unicast-routing is enabled.
- Configure IPv6 RIP on the interface.
04-26-2021 02:47 PM
Thank you for your reply ! One last question...
How do you configure RIP for IPv6 ? Any additional material / reference you may provide will be appreciated !
04-28-2021 07:20 AM
Here is the configuration guide for more information.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: