08-24-2014 06:34 AM - edited 03-04-2019 11:35 PM
How to setup the E1 WAN for data only with cisco 2951 routers and 2-port 3rd Gen. MFT E1 cards?
I need the complete IOS configuration for above routers.
Thanks.
08-24-2014 11:45 AM
Hi Exploited,
You'd need to provide a lot more information for a meaningful answer.
Are you using IPv4 or IPv6 on the network?
Figure out what transport protocol your going to be using, is this a fully meshed WAN link? Hub and Spoke? Point to Point? What routing protocol are you using? EIGRP? OSPF? BGP?
08-25-2014 08:39 AM
Hi Micheal,
following are the answers to your queries
IPv4 Class A private IP addressing
Point to Point, Hub-and-spoke topology
Planned to use EIGRP
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide