04-29-2020 07:44 PM
Hello guys ,
I am lab up a topology of Hub and Spoke (Phase 1) Dynamic Multiprotocol Virtual Private Network
I have used full-forms because page was not allowing to post shortcut keywords
I advertised all the underlay address in AREA 0 , all (underlay) for Hub-to-spoke and vice-versa reachable
Then i tried advertised Tunnel(overlay) and other address of hub and spokes using Enhanced Interior Gateway Routing Protocol, Spoke Tunnels formed neighbors with HUB, but after some time its going down with retry time exceeded logs
%DUAL-5-NBRCHANGE: EIGRP-IPv4 10: Neighbor 192.168.10.3 (Tunnel1) is down: retry limit exceeded
I read some of the article regarding this issue ,they suggests to change Maximum transmission unit and Maximum segment size of Tunnels to 1400 and 1360 respectively ,tried that too , but still same issue
Any suggestions and Solutions ?
Thanks in Advance
04-29-2020 08:42 PM
04-29-2020 09:04 PM - edited 04-29-2020 09:06 PM
btw, I have done a quick lab for your reference. Thanks for let me revisiting my Cisco exam material.
HUB:
IOU4# show run int t0 interface Tunnel0 ip address 172.16.0.1 255.255.255.0 no ip split-horizon eigrp 1 ip nhrp map multicast dynamic ip nhrp network-id 12345 ip nhrp holdtime 300 [Not a must, but enhance the stability issue due to IOU's bug] ip nhrp redirect tunnel source Ethernet0/0 tunnel mode gre multipoint tunnel protection ipsec profile IP end IOU4#sh run | s router router eigrp 1 network 172.16.0.0 router ospf 1 IOU4#sh run int e0/0 interface Ethernet0/0 ip address 192.168.1.1 255.255.255.0 ip ospf 1 area 0 end
Spoke
interface Tunnel0 ip address 172.16.0.3 255.255.255.0 ip nhrp map multicast 192.168.1.1 ip nhrp map 172.16.0.1 192.168.1.1 ip nhrp network-id 12345 ip nhrp holdtime 300 ip nhrp nhs 172.16.0.1 ip nhrp shortcut tunnel source Ethernet0/0 tunnel mode gre multipoint tunnel protection ipsec profile IP end IOU3(config-router)#do sh run | s router router eigrp 1 network 172.16.0.0 router ospf 1 IOU3(config-router)#do sh run int e0/0 interface Ethernet0/0 ip address 192.168.3.1 255.255.255.0 ip ospf 1 area 0 end
04-29-2020 09:56 PM
Thanks for the suggestion,but it did not work
i am using IOS 7200 , i did a another lab with 1-----2-----3 ,Point-to_Point connectivity between 3 routers ,and then configured same Enhanced Interior Gateway protocol for Overlay (Tunnel) , and Open Shortest Path First protocol for Underlay , just to confirm the issue was not with some sort of recursive routing , and the result is it worked fine , Neighbor-ship was stable
Then what's the issue?
Thanks
04-29-2020 10:29 PM
04-30-2020 02:29 AM
Solved , man i think IOS as some type of BUG ,now i mirrored the same setup but this time with IOU images ,
it worked fine , previously every 80 seconds it use to go down ,Now its stable
Output :
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide