Enabling Traps on a BPX 8600

[jrabener]

Good Day,

I'm trying to figure out how to configure traps on a BPX 8600 ATM Switch.

I'm interested specifically in the following:

cpuUtilizationAboveNormal

Specific Trap 20021

This trap is generated whenever a BPX/IGX/IPX processor's CPU utilization is above the threshold.

and

memoryUtilizationAboveNormal

Specific Trap 20023

This trap is generated whenever a BPX/IGX/IPX processor's dynamic memory utilization exceeds a fixed threshold. The alarm is reported from the node based on existing statistics that are collected for profiling the performance of the node.

Thanks

[b.hsu]

To configure traps we could use Cisco WAN Manager (CWM).Configure the network name and network CWM ID in the /usr/users/svplus/config/network.conf file. Refer URL

http://cisco.com/en/US/products/sw/netmgtsw/ps2340/products_technical_reference_chapter09186a00801ebb52.html#wp1000548

[jrabener]

Brian,

Thanks for your reply. The link you provided should be helpful in configuring these traps.

Best Regards!