03-22-2011 08:31 AM - edited 03-04-2019 11:50 AM
Hi,
While issuing the command “show ip accounting” on Cisco 10720 router the output is empty.
Command used for enable on serial intyerface:-
router(config)#int serial 0/0
router(config-if)#ip accounting output-packets
router(config-if)#exit
But while input below command:-
Router#sh ip accounting
Source Destination Packets Bytes
Accounting data age is 03:08
Please suggest on this.
03-22-2011 08:54 PM
Hi,
Please suggest on this.
we did not find any output for command router#show ip accounting output-packet
regards,
Rakesh
03-22-2011 09:24 PM
hi,
can you try on the LAN interface?
03-23-2011 05:37 AM
Hi,
I have already checked this on fastethernet port:-
Int fa2/12
ip accounting output-packets
But output is same:-
Router#sh ip accounting
Source Destination Packets Bytes
Accounting data age is 03:01
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide