error spawning telnet tasks

[harrisgirls]

Hi Guys,

I thought i would post this here also as i always get replies and answers here!!

I came in this morning to find 2 of my switches were not fully working, i could not http or telnet to them.

When I tried to telnet to one of them i got:

Sorry, error spawning telnet tasks.

Connection to host is lost.

Only way to clear this is to reboot the switch and all is good.

Network has been up fine for 4 months then this out the blue.

Switches were Procurve 2510G-48.

Thanks,

[Joseph W. Doherty]

Disclaimer

The    Author of this posting offers the information contained within this    posting without consideration and with the reader's understanding that    there's no implied or expressed suitability or fitness for any  purpose.   Information provided is for informational purposes only and  should not   be construed as rendering professional advice of any kind.  Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In    no event shall Author be liable for any damages whatsoever  (including,   without limitation, damages for loss of use, data or  profit) arising  out  of the use or inability to use the posting's  information even if  Author  has been advised of the possibility of such  damage.

Posting

"Procurve 2510G-48"  HP switches?  You're looking for advice on a Cisco forum?  Ah, of course, you're looking for suggestions for which Cisco switch to replace them with.

Sorry, couldn't resist, but seriously, these forums might not be the best place for obtaining good advice on HP switches.  In general, you might see if HP has newer code or any documented bugs for these models.

[harrisgirls]

Hi,

I posted on HP site but never get any replies and i've always posted here regards to hp stuff and always get an answer!