Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
225
Views
4
Helpful
1
Replies

Ether channel

Lavanholy
Level 1
Level 1

‎03-20-2008 10:38 AM - edited ‎03-03-2019 09:13 PM

Hi,

I have 2 Layer 3 Cisco 3560G switches,I have cascaded these two.

Now I have 30 bladed servers in Server VLAN,in that is it necessary to configure the Server VLAN in both 3560G switches.

Then there is a SUN NAS server,which has 2 GBIC NIC card,they have configured the BONDING,means bundling 2 gbic like,in that case we have to also configure the 2 switch port into single 2gbic unidirectional or 2GB bidirectional .Means basically we have to bundle 2 GIBIC port into single 2GBIC unidirectional or 4 GBIC bidirectional,we did fast etherchannel ,but it is not happening,Please clarify why it is not doing?How to do a BONDING in the Cisco switch.

Please help me to resolve the issue.

Thnaks and Regards,

S.venkataraman.

Labels:
0 Helpful
1 Reply 1

Edison Ortiz
Hall of Fame
Hall of Fame

‎03-20-2008 10:42 AM

Etherchanneling is only supported when sourcing from the same switch towards the same destination.

You can't have etherchanneling configured among 2 switches with the 3560G model. You could accomplish this task with the 3750G model which provides cross-stack features.

Posting your current config will help troubleshooting your case a lot better.

HTH,

__

Edison.

Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card