01-05-2007 03:14 PM - edited 03-03-2019 03:16 PM
Hey guys,
I have a 3840 router.
It has a Ethernet Swithing module (NME-16ES-1G-P).
After the IOS on the module was upgraded, the module now just keeps on restarting.
I see the error:
error: Hardware not supported by firmware. Try loading newer software.
Now obvioulsy the version we installed is worng.
Now my question is how to reach ROM MON on the module.
A lot of info is available for the IOS on the router but don't know how I can break that restarting sequence on the module.
Any help would be hightly appreciated.
Regards
01-05-2007 10:09 PM
Power cycle (switch off and then on) the router and press Ctrl-Break for 5-10 seconds when router is boting in order to generate break sequence. This should take router to the ROMMON mode.
hope it helps .. rate if it does ..
01-07-2007 11:38 AM
Hello,
Thanks for the reply.
Router doesn't keeps on rebooting. Once I access switching module by typing 'session x' i can see that the module is power cycling.
If it was the router that was rebooting, it wasn't a big problem.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide