Below is my problem and needing to know how to fix it. It won't go any further then
*Mar 1 00:00:12.792: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing
a cold start *Mar 1 00:00:12.792: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing
a cold start
Your assistance is greatly appreciated, i tried to google it but there problem was they didn't remember there password, but it doesn't let me do anything past this. I can't type anything into hyperterminal it just basically freezes there. Thank you in advance!
Processor board ID JAE0733067G (3967809213)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
4 Low-speed serial(sync/async) network interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
Slot is empty or does not support clock participate
WIC slot is empty or does not support clock participate
SETUP: new interface Serial1/0 placed in "shutdown" state
SETUP: new interface Serial1/1 placed in "shutdown" state
SETUP: new interface Serial1/2 placed in "shutdown" state
SETUP: new interface Serial1/3 placed in "shutdown" state
Press RETURN to get started!
*Mar 1 00:00:08.854: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state t
o up
*Mar 1 00:00:08.858: %LINK-3-UPDOWN: Interface Serial1/0, changed state to down
*Mar 1 00:00:08.858: %LINK-3-UPDOWN: Interface Serial1/1, changed state to down
*Mar 1 00:00:08.858: %LINK-3-UPDOWN: Interface Serial1/2, changed state to down
*Mar 1 00:00:08.858: %LINK-3-UPDOWN: Interface Serial1/3, changed state to down
*Mar 1 00:00:09.731: %SYS-5-CONFIG_I: Configured from memory by console
*Mar 1 00:00:10.004: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern
et0/0, changed state to down
*Mar 1 00:00:10.008: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/0,
changed state to down
*Mar 1 00:00:10.008: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/1,
changed state to down
*Mar 1 00:00:10.008: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/2,
changed state to down
*Mar 1 00:00:10.008: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/3,
changed state to down
*Mar 1 00:00:11.610: %LINK-5-CHANGED: Interface FastEthernet0/0, changed state
to administratively down
*Mar 1 00:00:11.947: %LINK-5-CHANGED: Interface Serial1/0, changed state to adm
inistratively down
*Mar 1 00:00:11.947: %LINK-5-CHANGED: Interface Serial1/1, changed state to adm
inistratively down
*Mar 1 00:00:11.947: %LINK-5-CHANGED: Interface Serial1/2, changed state to adm
inistratively down
*Mar 1 00:00:11.947: %LINK-5-CHANGED: Interface Serial1/3, changed state to adm
inistratively down
*Mar 1 00:00:12.788: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.3(20), RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Tue 08-Aug-06 20:50 by kesnyder
*Mar 1 00:00:12.792: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing
a cold start
Jeromy
