frame-relay end-to-end keepalive in a physical interface

[idn.wanggang]

Dear Sirs:

Frame-relay end-to-end keeplives can be configured in a fr sub-interface,how can we configure in a physical interface?

Best wish

[Georg Pauwen]

Hello,

TMBK, the EEK configuration for physical interfaces works the same as for subinterfaces, that is, you define the Frame Relay map-class and then apply it to the (physical) interface. Are you running into a specific problem ?

Regards,

GP

[idn.wanggang]

Hi,GP

Thank you for your reply.

In a subinterface,it works well,but in a physical interface,it does not work.

When one side is shutted down, the other side interface and line protocol still up.

Best Regards.

[Georg Pauwen]

Hello,

check if your interface is getting other DLCIs from the Frame Relay cloud, and if so, disable inarp (no frame-relay inverse-arp). Also, try and configure the EEK under the DLCI:

interface Serial0/0

encapsulation frame-relay

no frame-relay inverse-arp

frame-relay interface-dlci 102

class EEK

Does that make a difference ?

Regards,

GP

[idn.wanggang]

No.