Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
250
Views
0
Helpful
2
Replies

Gateway looping in network

prince.p
Level 1
Level 1

‎06-13-2018 04:38 AM - edited ‎03-05-2019 10:35 AM

Hi Support,

 

we are using Cisco 2960 series switches and SonicWall firewall. we configured the LAN gateway in Sonicwall interface as 10.1.0.10. and our subnet mask is 255.255.254.0

today someone in our network assigns a static IP address to Rasberry device lan interface as 10.1.0.200.

After they connect they connect the device in the switch all the DHCP assigned systeIPip address gateway changed to 10.1.0.200 and our internet connected get disturbed due to this.

can anyone give solution for the issue

 

 

 

 

 

Labels:
0 Helpful
2 Replies 2

paul driver
VIP
VIP

‎06-13-2018 04:48 AM - edited ‎06-13-2018 04:53 AM

Hello

Was that rasberry device by any chance servcing dhcp? 



Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
0 Helpful

prince.p
Level 1
Level 1
In response to paul driver

‎06-13-2018 04:52 AM

they are doing routing configuration in rasberry device.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card