Gateway to Gateway VPN waiting to connect help!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2018 02:31 PM - edited 03-05-2019 10:40 AM
I have 4 locations that are utilizing gateway to gateway connections. 3 locations have the Cisco RV325 Wan VPN Routers and one has an ASA. Under the VPN Summary tab the 3 VPN connections were all connected at one time and recently the status went to waiting for connection. Nothing has changed that could have caused this that im aware of. I tried switching them all to aggressive mode and back but it still goes back to "Waiting to connect".
There are 4 sites, Office 1, Office 2, Office 3, and Office 4.
All of the offices are connected to each other except office 2. Office 2 is waiting connection to all of them.
I've compared the settings side by side and they are all the same. HELP!
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2018 05:52 AM
Updated firmware, deleted connections, and reconnected successfully.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-30-2018 10:14 PM
Thanks for posting back to the forum and letting us know that you have solved the problem. +5 for that. My guess is that the update firmware might have been the important part of it.
HTH
Rick
Rick
