hi,
I have 2 routers,
2651 & 2811 configured with GLBP with following configs.
topology is like
ISPA---R1---SW---R2---ISPB
||
PIX515---Core
(but below config works for 3-4 mins after arp is build it stops working..) Any help
2651
----
interface FastEthernet0/0
ip address 192.168.2.2 255.255.255.0
duplex auto
speed auto
glbp 10 ip 192.168.2.1
glbp 10 preempt delay minimum 5
glbp 10 weighting 110 lower 90 upper 100
glbp 10 load-balancing weighted
glbp 10 weighting track 100 decrement 5
glbp 10 weighting track 101 decrement 5
glbp 10 forwarder preempt delay minimum 10
2811
----
interface FastEthernet0/0
ip address 192.168.2.3 255.255.255.0
duplex auto
speed auto
no cdp enable
glbp 10 ip 192.168.2.1
glbp 10 preempt delay minimum 5
glbp 10 weighting 110 lower 90 upper 100
glbp 10 load-balancing weighted
glbp 10 weighting track 100 decrement 5
glbp 10 weighting track 101 decrement 5
glbp 10 forwarder preempt delay minimum 10