GLC-T 1000Base-T SFP on ASR1002

[rwaqanitoga]

Hi members,

We faced interface down when trying to enable gi0/0/3 on ASR1002 to interconnect using a cat6 to a Cisco 6500 switch on gi6/1. The interface module used was a GLC-T 1000Base-T SFP(non cisco sfp)

interface GigabitEthernet0/0/3
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
negotiation auto
no mop enabled
end

TRANSCEIVER-6-INSERTED: SIP0/0: transceiver module inserted in GigabitEthernet0/0/3
TRANSCEIVER-3-INIT_FAILURE: SIP0/0: Detected for transceiver module in GigabitEthernet0/0/3, module disabled

Any timely assistance in resolving this issue will be much appreciated.

Regards,

rwaqanitoga

[rwaqanitoga]

Hi experts,

We even tried a Cisco brand SFP but still facing the issue(interface down)

Also need adding that for both non-cisco and cisco sfp there was a critical alarm

Hardware Status

Critical

This was only cleared by disabling the interface for gi0/0/3

Please assist...

Best Regards,

RWaqanitoga

[aorelli]

Did you ever managed to sort this issue? What was it? I believe we have the same