Help need to configure multiple gateway on l3 switch.

[cutehameed]

Hi everyone,

I have a l3 3750 switch and i have configured multiple VLANs as per my requirement. I want to know if i can configure multiple gateways, one gateway per vlan?

[MHM Cisco World]

if this SW will work as inter-vlan, then you need IP for each VLAN SVI 
and config this VLAN SVI IP as GW for host in that VLAN

[Flavio Miranda]

Hi

Maybe you are misunderstanding the concept of network devices. If you have a L3 switch, it is the gateway. What you need to do is setup interface vlan and routing with your next device which might be a firewall or a router depending on the topology.

 You dont need to add a gateway somewhere. Just run the command "ip routing" in order to route between Vlans

[Richard Burts]

The original poster asks "I want to know if i can configure multiple gateways, one gateway per vlan?". I would like to know more about why this is the case. But it is a simple question and there is an answer. Implementing Policy Based Routing would allow you to specify that vlan 10 uses one gateway, vlan 20 uses a second gateway, vlan 30 uses a third gateway, etc. If you need information about PBR we can provide it.