help with router 1841 configuration

[yossryhelal]

Hello,

I am trying to practice for the CCNA but I got issue with the cisco 1841 router config, So the issue is I connected I have f0/0 and f0/1 as dhcp but I see only f0/0 show assigned to ip address and up but f0/1 connected to my laptop but still shows unassigned, and NVI0 has ip address as well and up  any idea how I can make f0/1 to show assigned as f0/0 and be able to connect it to my lap as hardwire conneted ethernet??

Thank you!

[identit255]

So... Could you send full conf? Just the output of sh run command.

[yossryhelal]

interface FastEthernet0/0
ip address dhcp
shutdown
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/0/0:0
ip address 20.20.20.3 255.255.255.0
!
ip forward-protocol nd
!
!
no ip http server
!
!
!
control-plane
!
disable-eadi
!
!
line con 0
line aux 0
line vty 0 4
login
transport input all
!
scheduler allocate 20000 1000
end

R3#

[identit255]

These two following actions should fix your problem, if i have clearly understood your problem:

1) Both your interfaces (f0/0 and f0/1) are in a shutdown state, you have to turn them on by executing no shutdown command.

2) You have to apply ip address dhcp command on interface f0/1to get a ip address.

Hope this help.

identit255

[identit255]

Plus as I see the dhcp server is not configured locally, so you have to set dhcp relay ip address.

[M02@rt37]

Hello @yossryhelal,

What do you want to do?

Connect PC on fa 0/0 and fa 0/1 and deliver IP address to that PCs ?

If yes! Give an IP add. to these interfaces as Gateway of PCs and configure DHCP server on 1841 to deliver IP add to PCs.

If no! Please more elaborate.

Thanks.