How to access another VLAN via my gateway to gateway connection
just wondering if anyone wiser than me can help. I have setup my gateway to gateway connection ok and I can access each side.
in the office I have now created two more VLAN networks on the RV320
I am trying to set it up so that the remote site can access all the networks (more for Remote Desktop to the servers)
i can see in the Gw to Gw setup, the RV320 asks for a subnet of each site and I can’t seem to add the new networks to this section. I have also read about using the Advanced Routing option. The VLAN are created and have enable inter VLAN access. When I am in the office I can access all the networks but not over the GW to GW connection. Can anyone help
Re: How to access another VLAN via my gateway to gateway connection
With any VPN setup you will typically require an ACL which is used to identify "interesting" traffic (the encryption domain) destined for the remote end which will be sent via the VPN.
Looking at the RV320 configure guides it would appear that you can only define a single subnet in this ACL. The issue you have is the 192.168.2.0 subnet lies between 192.168.1.0 and 192.168.10.0 and 192.168.20.0.
Due to this limitation you need to ensure each site is allocated a contiguous address block (this would be good practice TBH) ,eg:
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Do you currently have hands-on networking experience? If you do, we'd love to hear from you!
Your feedback will be reviewed and analyzed by our team to directly influence a networking management and monitoring product.
Take the 20-min or les...