Hi All
i need help to configure Multicast PIM Sparse Mode with RP Redundancy for Network Devices without Dynamic Routing Protocol (only static route) . i have following queries
1- can we configure Multicast PIM sparse mode with Dual RP and with Static IP configured on connected device (without any Dynamic Routing Protocol ( if yes then which method will work Anycast RP, Auto RP, BSR )
2- if Dual RP cannot be achieve by using Static Routing then what should be the exact method to achieve
3- is there any way we can achieve RP redundancy with static Routing instead of dynamic routing
4- why we cannot configure static Routing with dual RP/ RP backup ?
PIM Sparse Mode
Multicast Source
! L3 SW1 L3 SW2
RP1 ---!!!!!!!!-------------------!!!!!!!!!!--- RP2 HSRP running between SW1 and SW2
! ! HSRP VIP is gateway for SW3 and SW4
L3 Link ! ! L3 Link
! !
!!!!!!!-------------------!!!!!!!!!!-----------Multicast Receiver
L3 SW3 L3 SW4 HSRP running between SW3 and SW4
HSRP VIP is gateway for Multicast Receiver
we have defined static routing all over the place
waiting the expert opinion
any help will be appreciated
real topology also attached
