cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
347
Views
0
Helpful
1
Replies

How to Allow pinging of PC-A to Router 1?

JT4
Level 1
Level 1

Question

There are two PC's on different subnet masks and the Multilayer switch is how I am doing the routing for them to ping. However whenever I try and ping the router, it always comes back with 'host destination unreachable'. For this particular test i am trying to implement an ACL and know that it is possible on the MLS but then the routing seems to be disabled. Any advice for either reaching the router or implementing the ACL on the MLS?

Answer

1 Reply 1

Hello

I cannot access the devices in your PT file what are the access credentials?


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: