12-09-2014 03:01 PM - edited 03-05-2019 12:19 AM
We have Cisco 4503 switch. We can login it using Cisco Network Assistant. But can't login it using telnet. It prompts for the password. No one knows the password. How can we change the telnet password, perhaps enable password too from the Network Assistant?
Solved! Go to Solution.
03-09-2015 06:57 AM
Have you configured Telnet access on the vty lines on the 4503?
http://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/ios-software-releases-121-mainline/46960-config-telnet.html
03-09-2015 07:47 AM
Hello Chicagotech,
Tim is correct. Verify if you have telnet enable on you Cisco 4503 switch. If you implement the following command in Exec mode, that should provide assistance for you.
switch# show users
Additional Resources:
Regards,
Jordan Tazewell
03-09-2015 06:57 AM
Have you configured Telnet access on the vty lines on the 4503?
http://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/ios-software-releases-121-mainline/46960-config-telnet.html
03-09-2015 07:47 AM
Hello Chicagotech,
Tim is correct. Verify if you have telnet enable on you Cisco 4503 switch. If you implement the following command in Exec mode, that should provide assistance for you.
switch# show users
Additional Resources:
Regards,
Jordan Tazewell
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide