03-15-2007 09:58 AM - edited 03-03-2019 04:10 PM
Hi,
I have a 2M ATM circuit on RJ45. Is there any special requirement for a 2811 with AIM-ATM module to use the ATM circuit? Any sample config?
03-15-2007 10:54 AM
Lets say you have AIM card in slot 1 and VWIC card installed in WIC2 slot
network-clock-participate wic 2
network-clock-participate aim 1
network-clock-select 1 E1 0/2/0
controller E1 0/2/0
mode atm aim 1
interface ATM0/IMA3
no ip address
no atm ilmi-keepalive
interface ATM0/IMA3.77 point-to-point
pvc 1/77
ubr 3840
oam-pvc manage 0
encapsulation aal5snap
interface ATM0/2/0
no ip address
no scrambling-payload
ima-group 3
no atm ilmi-keepalive
Hope this helps.
03-15-2007 08:50 PM
Hi,
Unfortunately I do not have any VWIC card installed. Can I used the FastEther since the 2M ATM that the ISP provide is on RJ45?
03-15-2007 08:58 PM
Unfortunately you cannot get away by terminating at FastE, I know ISP provides RJ45 but that must be getting terminated on VWIC on 2811. RJ45 do not understand ATM format hence you would need a vwic at a minimum in order to turn up the ckt.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide