How to configure rate limit in catalyst 2960

[hiromushi]

Hello,

We have Catalyst 2960, we must limit the input output interfaces at a constant rate (eg 40Mb / s). rate-limit function is not currently supported, is what you intend to change the ios for the function is supported?

if not, how I can do to meet this need?

thank you for your reply

[Giuseppe Larosa]

hello David,

by using QoS you can  limit outbound

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_53_se/configuration/guide/swqos.html#wp1253412

This example shows how to limit the bandwidth on a port to 80 percent:

Switch(config)# interface gigabitethernet0/1

Switch(config-if)# srr-queue bandwidth limit 80

I'm afraid nothing can be done for inbound

Hope to help

Giuseppe

[u1kumar2002]

Hi,

    Agreed to above answer. For more information Plz vist : http://startnetworks.blogspot.com/2010/08/rate-limit-on-switches.html

Here you can find with examples and some more ways.

Do rate for helpful posts...

Uttam

http://startnetworks.blogspot.com/