Routing

HiI have a problem with Cisco ISR G2 2911 series routers. One of our clients  has 50 routers in WAN network. All routers are totally new and in function only three months. BUT, three of them are DEAD. When I say DEAD I mean: they have no cooler activ...

Dear All,What is the best practice of the routing for LAN and WAN,Is it OSPF & BGP or EIGRP & BGP?Really appreciated for any reply.Regards,sam

Hello Everyone,I'm hoping someone will be able to help me figure out an issue that I'm having. I'm sure it's something simple that I'm missing.  What I have is a site to site vpn tunnel between a Cisco 2801 and a Cisco 1841 router.  The tunnel itself...

I am going through several devices where static routes have been used and I am migrating them to EIGRP internally. I want to know of a command I can use on the routers to verify that once I remove the static route EIGRP knows about the routes and wil...

Hi all. I have a customer with a 5510 ASA and they only have one public ip address. They need to terminate the annex M adsl on a 877ISR. Does anyone have a sample configuration that will allow me to pass the ip address from the 877 onto the ASA? All ...

Anyone who can explain to me the below tracetcp and tracert that I have gathered. From hop 4-12 show high latency but at the end it shows low latency result, is this acceptable? why at middle show high latency values? Thanks1       1 ms    1 ms    1 ...

Hi all,I had a 2821 cisco router with a lot of vlans on a same interface. This is a Wan router, each vlan is connected to a trunk to my ISP and directly connected to a SDSL oneacces ONE60 modem. I want to replace 2 one 60 in the same location by a 18...

HI All,         Can we bundle different bandwidth of link(one is 64Kb &other one is 256Kb)  in Multilink interface ?

Hi,We are currently doing performance test of our application that is currently on staging and production stage. Does anyone knows of a tool that can measure how well the application will perform on a certain network condition? Or how to best trouble...

I'm sure this will be simple for most of you. I just have never done it. We have an MPLS WAN and we qos various traffic into Normal, Priority, Critical, Video and Voice planes based on default qos markings or ip address.I have a couple servers that a...