cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
11624
Views
0
Helpful
1
Replies

How-to configure Sup2T management ports in a dual-sup chassis?

bgfl-tech
Beginner
Beginner

Hi,

We've just invested in a pair of Sup2Ts to upgrade a Sup720 6509 chassis but I'm unsure exactly how the management port(s), aka the

Connectivity Management Processor (CMP), should be configured (and patched) in a dual supervisor system?

Is each CMP an independent entity or is the management interface configuration (IP address, gateway, etc) replicated between supervisors?

If it's the latter then do both management ports need to be physically connected at the same time?

Thanks in advance

Matthew

1 Accepted Solution

Accepted Solutions

Edison Ortiz
Hall of Fame Mentor Hall of Fame Mentor
Hall of Fame Mentor

CMP should be treated as a separate entity and there is no replication of such information between supervisors.

For more information, please refer to the documentation:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/cmp_configuration/guide/cmp_overview.html

View solution in original post

1 Reply 1

Edison Ortiz
Hall of Fame Mentor Hall of Fame Mentor
Hall of Fame Mentor

CMP should be treated as a separate entity and there is no replication of such information between supervisors.

For more information, please refer to the documentation:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/cmp_configuration/guide/cmp_overview.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: