05-23-2022 07:30 PM - edited 05-23-2022 07:35 PM
how to connect this router (the one at the top) to the 3 switches at the bottom, these are 2 different networks with 2 different subnet masks. I did the interface encapsulation but it doesn't send packets from any pc in Sales & Marketing Network (the left one) to R&D Network(the right one) or vice versa. I set the port of the switch between the middle switch and the router to trunk and gave all to it, then the left port to vlan 3 and the right port to vlan 2, the left switch has the up port set to access and vlan 3, the right switch has the up port set to access and vlan 2, all the down ports in the left and right switch are set to vlan 1(default). all packet sent shows failed state
Solved! Go to Solution.
05-24-2022 12:21 AM
You need to put the ports connected to the PCs etc. into the correct vlan so vlan 2 on left switch and vlan 3 on right switch.
Jon
05-24-2022 12:21 AM
You need to put the ports connected to the PCs etc. into the correct vlan so vlan 2 on left switch and vlan 3 on right switch.
Jon
05-25-2022 12:21 AM
It worked but after i closed the project and reopened it, it completely stopped functioning
05-25-2022 12:47 AM
Hello,
post the zipped project (.pkt) file.
05-24-2022 12:42 AM
Hello,
post your zipped Packet Tracer project (.pkt) file...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide