cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
430
Views
0
Helpful
1
Replies
Highlighted
Beginner

How to enable onePK on CSR1000V?

I am running:

Cisco IOS XE Software, Version 03.11.01.S - Standard Support Release

Cisco IOS Software, CSR1000V Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.4(1)S1, RELEASE SOFTWARE (fc2)

using license:

License Level: premium

License Type: Evaluation License

Next reload license Level: premium

Index 24 Feature: prem_eval

        Period left: 8  weeks 3  days

        License Type: Evaluation

        License State: Active, In Use

        License Count: Non-Counted

        License Priority: Low

The onePK status shows:

CSR#sh onep status

Status: enabled

Version: 1.1.0

Transport: tcp; Status: disabled

Transport: tls; Status: disabled

Transport: tipc; Status: running; Port: 15003

Session Max Limit: 10

CPU Interval: 0 seconds

CPU Falling Threshold: 0%

CPU Rising Threshold: 0%

History Buffer: Enabled

History Buffer Purge: Oldest

History Buffer Size: 32768 bytes

History Syslog: Disabled

History Archived Session: 0

History Max Archive: 16

Service Set: Base               State: Enabled     Version 1.1.0

Service Set: Vty                State: Disabled    Version 0.1.0

Service Set: OneFW              State: Disabled    Version 0.1.0

Service Set: Mediatrace         State: Disabled    Version 1.0.0

I would like to enable Transport: tcp, but I dont know how to.

The transport command is not recognized:

CSR(config)#onep

CSR(config-onep)#transport?

% Unrecognized command

CSR(config-onep)#?

ONEP configuration commands:

  cpu      CPU resource

  default  Set a command to its defaults

  exit     Exit from ONEP configuration mode

  history  One Platform History Trails

  no       Negate a command or set its defaults

  service  ONEP service set

  session  One Platform Session

What else could I try? Am I missing something?

Thanks!

Everyone's tags (4)
1 REPLY 1
Highlighted
Cisco Employee

OnePK is supported from

OnePK is supported from version 3.12.0 onwards

CreatePlease to create content