Hello Georg Pauwen,
I don't know exactly about voice card installed or not. Here no one is there to support me, I am only person in this Company.
You Asked me to 2 Questions
1. sh version
Router#
Router#sh ver
Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.4(3)M3, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Fri 05-Jun-15 13:24 by prod_rel_team
ROM: System Bootstrap, Version 15.0(1r)M16, RELEASE SOFTWARE (fc1)
Router uptime is 14 hours, 15 minutes
System returned to ROM by power-on
System image file is "flash0:c2900-universalk9-mz.SPA.154-3.M3.bin"
Last reload type: Normal Reload
Last reload reason: power-on
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco CISCO2911/K9 (revision 1.0) with 483328K/40960K bytes of memory.
Processor board ID FGL20051099
2 FastEthernet interfaces
3 Gigabit Ethernet interfaces
1 terminal line
DRAM configuration is 64 bits wide with parity enabled.
255K bytes of non-volatile configuration memory.
255488K bytes of ATA System CompactFlash 0 (Read/Write)
License Info:
License UDI:
-------------------------------------------------
Device# PID SN
-------------------------------------------------
*1 CISCO2911/K9 FGL20051099
Technology Package License Information for Module:'c2900'
------------------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------------
ipbase ipbasek9 Permanent ipbasek9
security None None None
uc None None None
data None None None
NtwkEss None None None
CollabPro None None None
Configuration register is 0x2102
-------------------------------------------------------------------------
2. Router Configuration
Router#sh run
Building configuration...
Current configuration : 3883 bytes
!
! Last configuration change at 23:50:07 UTC Wed May 10 2017 by cisco
!
version 15.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
logging buffered 51200 warnings
!
no aaa new-model
!
!
!
!
!
!
!
!
!
!
!
!
!
!
ip domain name yourdomain.com
ip name-server 202.xx.xx.xx
ip name-server 202.xx.xx.xx
ip cef
no ipv6 cef
multilink bundle-name authenticated
!
!
cts logging verbose
!
!
license udi pid CISCO2911/K9 sn FGL20051099
!
!
archive
log config
hidekeys
username cisco privilege 15 secret 5 $1$C1ou$Z3.IK7HGs762bA8qFPcbH1
!
redundancy
!
!
!
!
!
!
interface Embedded-Service-Engine0/0
no ip address
shutdown
!
interface GigabitEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-FE 0$
ip address 125.xx.xx.xx 255.xx.xx.xx
ip nat outside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet0/1
ip address 192.168.1.1 255.255.255.0 secondary
ip address 125.xx.xx.xx 255.xx.xx.xx
ip nat inside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet0/2
no ip address
shutdown
duplex auto
speed auto
!
interface FastEthernet0/0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-FE 0$
ip address 10.1.95.134 255.255.255.252
duplex full
speed 100
!
interface FastEthernet0/0/1
ip address 172.17.122.1 255.255.255.0
duplex auto
speed auto
!
ip forward-protocol nd
!
ip http server
ip http access-class 23
ip http authentication local
no ip http secure-server
ip http timeout-policy idle 60 life 86400 requests 10000
!
ip nat pool webcomet 125.xx.xx.xx 125.xx.xx.xx netmask 255.xx.xx.xx
ip nat inside source list 20 pool webcomet overload
ip route 0.0.0.0 0.0.0.0 125.xx.xx.xx
ip route 121.244.43.0 255.255.255.0 10.1.95.133
ip route 172.17.122.0 255.255.255.0 10.1.95.133
ip route 203.200.231.0 255.255.255.0 FastEthernet0/0/0
!
!
!
access-list 20 permit 192.168.1.0 0.0.0.255
!
control-plane
!
!
banner exec ^CCCC
% Password expiration warning.
-----------------------------------------------------------------------
Cisco Router and Security Device Manager (SDM) is installed on this device and
it provides the default username "cisco" for one-time use. If you have already
used the username "cisco" to login to the router and your IOS image supports the
"one-time" user option, then this username has already expired. You will not be
able to login to the router with this username after you exit this session.
It is strongly suggested that you create a new username with a privilege level
of 15 using the following command.
username <myuser> privilege 15 secret 0 <mypassword>
Replace <myuser> and <mypassword> with the username and password you want to
use.
-----------------------------------------------------------------------
^C
banner login ^CCCC
-----------------------------------------------------------------------
Cisco Router and Security Device Manager (SDM) is installed on this device.
This feature requires the one-time use of the username "cisco"
with the password "cisco". The default username and password have a privilege level of 15.
Please change these publicly d> with the username and password you want to use.
For more information about SDM please follow the instructions in the QUICK START
GUIDE for your router or go to http://www.cisco.com/go/sdm
-----------------------------------------------------------------------
^C
!
line con 0
logging synchronous
login local
line aux 0
line 2
no activation-character
no exec
transport preferred none
transport output pad telnet rlogin lapb-ta mop udptn v120 ssh
stopbits 1
line vty 0 4
privilege level 15
password xxxxxxxx
login
transport input telnet
line vty 5 15
access-class 23 in
privilege level 15
login local
transport input telnet
!
scheduler allocate 20000 1000
!
end
