I need your help to monitor or to see the bandwidth of vlan on switch, I read that this process is with VLAN access maps but I don’t know how.
Could you give me one example of configuration?
Thanks in advance
How is your network monitoring tool configured? Do you want to a span port to direct traffic to this device for analysis?
If so see below an example config for a 6500
A simpler alternative is to use SNMP polling to monitor bandwidth consumption on a VLAN interface.
Please remember to rate posts that are helpful.
Do the VLANs only exist on the VMWare Server?
Assuming your 4500 switch has the capability I would suggest configuring Netflow.
This will allow you to graph bandwidth utilization for source and destination IP addresses.