Routing

hi i´m looking for the signed document "declaration of conformity" of an WS-C2940-8TF-S eg http://www.cisco.com/en/US/prod/video/ps11070/ps11102/MP2240xx_CE__DoC.pdfI find only general information .... XX Statement - Declaration of ... without signat...

Hello,I would like to know if I can configure my UC520 to support Dual WAN for failover or Bonded DSL.To add a second WAN do I need to add any upgrade module to UC520?Thank You,Sean

Hi all,I'm a bit lost with an issue on ISDN interfaces...I'm using ISDN for satellite needs and I'm facing a strange issue on one vessel. Let me explain the case :From the vessel to the HQ ISDN concentrator : everything is OK (here is the debug isdn ...

So,without going into it too deeply ...All I need to know is, if I create a GRE tunnel from my 4507 to the 6500k will the AD no longer been seen as 170 for external and be seen as AD 90.I'm assuming it will but if anyone here can poke holes in my the...

I have the following config::!interface Vlan 10 ip address 10.45.61.129 255.255.255.240 ip virtual-reassembly in ip tcp adjust-mss 1380 ip policy route-map 10-Net!route-map 10-Net permit 10 match ip address 107 set ip next-hop 192.168.112.126 192.168...

Hey all, we've done a lot of back and forth between our Internet provider and the destination host network support team and have not been able to find a solution. By now it's pretty clear the "ghost" is downstream somewhere on the Internet but I just...

Hi, I've used the following link to configure VPN access and have internet routed via the terminating router. http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a008073b06b.shtml My issue is when connected to the...

Has anyone seen this before.  The supernet shows up as a /24 and the new vlan 2 doesn't have a subnet assigned to it.4506#sh ip roCodes: C - connected, S - static, R - RIP, M - mobile, B - BGP       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF...

dear all i have got an aeronet AIR-AP1242AG-E-K9.. but the signal strenght of this device is really bad.. after 10 mtrs only it goes from good to bad.. means arounf 45% where as i have got another unbranded device which is far batter then cisco.. is ...

I have a Cisco 2800 series ISR receiving 2 WAN links a 5Mbps fiber link and a 1.5Mbps T1. The Fiber is connected to the ISR on gigabit Ethernet 0/1, the T1 is on Serial 0 and our LAN side is connected on 0/0 to an HP Procurve Switch 3500-24. I am usi...

Hi,What is the process for managing a NM-16ESW-1GIG module inserted in a Cisco ISR2 3925 Router? I could setup the switch through the CLI, but would like to activate the Gig port and perform some other modifications. If I’m not wrong I need to activa...

When sending the command “show interfaces summary” only the 16 Fast Ethernet ports of the NM-16ESW-1GIG are displayed. The Gigabit Ethernet port is not in the list. What’s the problem?