01-28-2019 05:45 PM
I have 5 static IPs from ISP
I have two border routers. I want to run HSRP for outside.
R1: int gig 0/0 20.20.20.1 255.255.255.248
ip nat outside
ip route 0.0.0.0 0.0.0.0 20.20.20.6
R2: int gig 0/0 20.20.20.2 255.255.255.248
ip nat outside
ip route 0.0.0.0 0.0.0.0 20.20.20.6 10
R1 and R2: standby 1 ip 20.20.20.3
QUESTIONS:
how to set up nat so all outgoing traffic has source of 20.20.20.3
how to set up nat, so I can use rest of the IPs. (20.20.20.4, 20.20.20.5)
I want to host 2 different web servers on these IPs
I have anyconnect on 20.20.20.3
01-28-2019 08:23 PM
01-28-2019 08:25 PM
Firstly the IP 20.20.20.3 is an internal Lan IP which should not be the source IP for the outgoing packets.
how to set up nat so all outgoing traffic has source of 20.20.20.3
Not possible if you use PAT so that all the outgoing traffic takes outside interface IP
how to set up nat, so I can use rest of the IPs. (20.20.20.4, 20.20.20.5)
You can use the rest of the IP's inside the LAN with no issues
I want to host 2 different web servers on these IPs
You can use these IP's in the LAN either in PC or servers doesnt matter, packets will be routed via the active router.
I have anyconnect on 20.20.20.3
Not sure about this , as you are using it as virtual IP, how you are expecting to configure same IP in the anycast.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide