Hallo,
I would like to understand how to verify the active and standby routers in our network on the core switch. From the snippet below, HSRP is configured on the transfer VLAN 828 to the ISP. The 'sh standby brief' command is not on the NEXUS switch. Do Nexus9000s support HSRP and if so, how do you check the other switches in the HSRP group?
R3# sh run int vlan 830
interface Vlan828
no shutdown
no ip redirects
ip address X.X.X.X /28
no ipv6 redirects
hsrp version 2
hsrp 828
preempt
priority 150
ip X.X.X.X
R3# sh stand?
^
% Invalid parameter detected at '^' marker.
