11-05-2008 04:03 AM - edited 03-04-2019 12:12 AM
i'm trying to install the NPE-G2 on Cisco Router 7206VXR but the keying post on the NPE-G2 stock in the end of the chassis.
Anybody have this problem before please help ASAP
11-05-2008 04:24 AM
Could you please capture the router booting sequesnce and paste it here.
11-05-2008 04:42 AM
11-05-2008 07:28 AM
Hello Anas,
are trying to insert the NPE-G2 in place of the current NPE ?
Be aware that in same side of PAs there is the I/O controller
verify that the chassis is 7206VXR and not a C7206.
boot with the old NPE and issue
show c7200
and check the chassis type
Hope to help
Giuseppe
11-06-2008 05:09 AM
Hello Giuseppe
thank you so much for your help.
i notice that there is two NPE-G2 version one with keying post and one without and the chassis that i have don't support the new one and i think i should get the older version of NPE-G2 i don't think that i have another choice.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide