Routing

I have seen other QosS questions, but have some that apply to me that maybe someone can help with.We have Main branch with 9M (X6 T1) that holds call manager and all the voice servers (IPCC, Unity).The 6 remote branches have T1s with 768k CAR from th...

HiI have 8 E1 line to connect another site.I configure multilink and get bandwidth 17 Mbs. but suddenly when 1 e1 is down then total link is down but show multilink is up. i can not ping connect site. when i pull out the faulty e1 then again connecti...

Hello,I was hoping someone could assist with providing me details or perhaps a link where I can find the default configuration settings of the WIC-1DSU-T1-V2. We are trying to determine - the out of the box - default behavior of this module and what...

hi,where can I download SDM ?I need it for my Cisco 837 ?best regards

Hi,First Happy new year for 2009.I have a Catalyst 3560-48PS-S in 12.2(46)SE IPBASEK9 IOS and I can't apply a "service policy-map input" on my L2 IP Phone FastEthernet ?This syslog is displayed :%QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not su...

I Guys, Is there someone who can help me on how to run a Ghost server in my 3500xl switch. Thanks,Jong

I have a site running EIGRP that has two possible gateways. Currently, one of the gateways is a 10MB PTP that I want to use as the primary.I have a 1.5 MB PTP that I would like to use as a backup (only if the 10mb fails). Here is my question - I pu...

I have an ASA that can't ping ip addresses that end with an even number. For instance I can ping 4.2.2.3 and 4.2.2.1 but can't ping 4.2.2.2 I've tried with different ip addresses but it's always the same result. Any ideas?

Hello,For the most part I understand the purpose of clocking. The majority of our circuits are Sprint MPLS and the clocking is derived from the line.What I'm confused about is how to configure clocking on a pair of routers that are connected to each ...

Hi ALL:My switch is in rommon and i dont have opton for xmodem and tftpdnldso i tried to boot the switch from the ios on tftp,but when doing that i am getting the following errorany idea whyi have tried Bothrommon 86 >boot tftp://192.168.112.7/tftpbo...

need 12mbps on WAN. Would it be best to do 12 PRI's and do MLPPP to remote 18 sites or can I have NM-1A-T3/E3 module to support MLPPP to these remote site that may have 1 or 2 PRI's off a VWIC2-MFT module? THXS for your quick responses

Multilink in 7609 Router, in that 3E1 links are connected in PA-MC-8TE1 Card and 3E1 links are connected in STM 1 Card. This E1 links are not working properly when configuring in single Multilink. Individually links are working fine and with seperate...