04-05-2012 07:21 PM - edited 03-04-2019 03:56 PM
I upgrade to a Flash 32mbs memory stick, as I reboot the 2600 Cisco router, it appear in the ROMMON mode,
nonetheless, I followed some wrong procedure by changing components on the ROMMON command line illustrated below,
however now the router reboot or start with symbol only V2V2v2a, and I can no longer enter the ROMMON Mode or key
anything in.
Any suggestion on how I could repair this problem????? I have a copy of the IOS on my TFTP server.
The following display shows an example of the confreg command I perform
rommon 7> confreg
Configuration Summary
enabled are: break/abort has effect console baud: 9600 boot:
the ROM Monitor do you wish to change the configuration? y/n [n]: y
enable "diagnostic mode"? y/n [n]: y
enable "use net in IP bcast address"? y/n [n]: y
disable "load rom after netboot fails"? y/n [n]:y
disable "use all zero broadcast"? y/n [n]: y
disable "break/abort has effect"? y/n [n]: y
enable "ignore system config info"? y/n [n]: y
change console baud rate? y/n [n]: y
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400
4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 [0]: 7
change the boot characteristics? y/n [n]: y
enter to boot: 0 = ROM Monitor 1 = the boot helper image 2-15 = boot system [0]: 2
Solved! Go to Solution.
04-05-2012 07:37 PM
Hello,
I see you changed the baud rate of rommon to 115200:
change console baud rate? y/n [n]: y
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400
4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 [0]: 7
Are you now consoling with correct baud rate set on your terminal application? Can you try changing that?
Nik
04-05-2012 07:37 PM
Hello,
I see you changed the baud rate of rommon to 115200:
change console baud rate? y/n [n]: y
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400
4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 [0]: 7
Are you now consoling with correct baud rate set on your terminal application? Can you try changing that?
Nik
04-05-2012 07:53 PM
Within the hyper terminal, I set the port setting to 9600 bit, however I can’t key anything within the console command line. Any suggestion on how to get around this problem and change baud rate, if not through the hyper terminal?
Yes Nik, I Change the hyper terminal to 115200 bit ps and everthing work.
Thank You !!!!
Jesse R
04-05-2012 09:36 PM
No probs, Glad it helped.
Nik
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide