Identifying PA-4T / PA-4T+

[rds-ryton]

How can I identify if my routers have PA-4T or PA-4T+ cards?

[icabrera · Accepted solution]

Hi, at the next url you can see how to do it:

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_module_installation_guide_chapter09186a008010f17a.html

"To determine if a PA-4T+ or PA-4T is installed in your router, view the port adapters' faceplate labels or use the show diag command to view installed interface types"

Hope this helps,if so please rate it.

[smothuku · Accepted solution]

Hi ,

You can identify PA-4T and PA-4T + using sh diag command on router.

Ex:PA-4T

Cisco 7200 Series Routers

Following is an example of the show diag slot command that shows a PA-4T in port adapter slot 1 of a Cisco 7200 series router:

Router# show diag 1

Slot 1:

Serial port adapter, 4 ports

Port adapter is analyzed

Port adapter insertion time 2d09h ago

Hardware revision 1.1 Board revision A0

Serial number 4294967295 Part number 73-1556-04

Test history 0x0 RMA number 00-00-00

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 02 01 01 FF FF FF FF 49 06 14 04 00 00 00 00

0x30: 50 00 00 00 FF FF FF FF FF FF FF FF FF FF FF FF

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_module_installation_guide_chapter09186a008010f02d.html

Following is an example of the show diag slot command that shows a PA-4T+ in port adapter slot 1 of a Cisco 7200 series router:

Router# show diag 1

Slot 1:

Mueslix serial (RS232) port adapter, 8 ports

Port adapter is analyzed

Port adapter insertion time 2d09h ago

Hardware revision 255.255 Board revision UNKNOWN

Serial number 4294967295 Part number 255-65535-255

Test history 0xFF RMA number 255-255-255

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 0D FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_module_installation_guide_chapter09186a008010f178.html

Hope it clarifies you.Plz rate it.

Thanks,

satish

[icabrera]

sorry, I didn't want to post another message, but there's no way to erase it.

regards