cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
469
Views
0
Helpful
1
Replies

inter vlan routing stoping

Hi,

we need config on WS-C3560G-24TS-S inter vlan communication stoping as per attached document.

1 Accepted Solution

Accepted Solutions

twhittle1
Level 1
Level 1

Hi Raja,

It is possible to control access between VLANs with Access Control Lists (ACLs), either normal ACLs or VLAN ACLs (VACLs) depending on how you have your network configured.

Below is a link to the configuration guide for Cataylyst 3560s showing you how to create these:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_58_se/configuration/guide/swacl.html

If you get stuck I advise more specific configuration commands but I'd need to know a little more information on how the swicth is configured (a show run would do it).

Regards,

Tom

View solution in original post

1 Reply 1

twhittle1
Level 1
Level 1

Hi Raja,

It is possible to control access between VLANs with Access Control Lists (ACLs), either normal ACLs or VLAN ACLs (VACLs) depending on how you have your network configured.

Below is a link to the configuration guide for Cataylyst 3560s showing you how to create these:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_58_se/configuration/guide/swacl.html

If you get stuck I advise more specific configuration commands but I'd need to know a little more information on how the swicth is configured (a show run would do it).

Regards,

Tom

Review Cisco Networking products for a $25 gift card