Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I'm configuring remote access on an ASA5505 and have it a popular stumbling block. The Remote access VPN has connected but I cannot access internal resources or the internet. weirdly I can ping the external interface. It's a full tunnel VPN. ...
Hi All, I'm trying to learn about Cisco Wireless, building a lab at home, and I've hit what I think is a very basic hurdle. I've deployed a vWLC, connected to a C3560 switch with a couple of APs hanging off. The vWLC only supports Flexconnect mode so...
Hi All,
I've got an issue on which I'm running out of ideas. Can anyone offer me any advice / point me in the right direction?
I have recently switched broadband providers. I have a VDSL service from talktalk business (prev talk talk consumer) an...
Hi All,
I'm having issues with getting CUCM 11.5 to transfer a file from a ftp server and I think I must be missing something odvious. Can anyone assist?
I'm trying to send a new cop file for a phone to the CUCM to upgrade the firmware used.
Wh...
Hi All,
Quick little question because I can't find the answer.
Does CUCM support an out of band management connection? when I install the virtual appliance it comes with 1 ethernet interface. What I'd like is to add a 2nd interface for out of band...
I've got an update on this. I've had confirmation from Cisco today that central authentication isn't supported on the vWLC. The previous responder was absolutely correct. The release notes are misleading, implying it is possible in small environment...
Hi, Thanks for the below. That's an interesting point, I bet the vNIC is 1Gbps, I think ESXi defaults to 1Gbps, I'll check later when I get back. I wonder if I could find a way of getting the virtual interface to be 100Mbps if central switching would...
Hi, Many Thanks for your response, and for replying so quickly! I had a look around and I was under the impression Cisco changed the central switching support from version 8.2.When I look in the release notes, version 8.0 says:FlexConnect central swi...
Hi,
Thanks for the below.
It's currently plugged into the VDSL interface. The presentation is RJ11 from the phone jack. Would it work plugged into the Ethernet interface? Same configuration just with WAN mode Ethernet as opposed to WAN mode DSL?
...