12-02-2016 01:57 AM - edited 03-05-2019 07:35 AM
I have created new interface Dialer 2 on the router Cisco 3825. I have associate same with Fastethernet port. A virtual Access interface has been crated for same automatically. However Dialer 2 interface not getting IP address from Modem.
There is already one Dialer interface running on the router for which when I check configuration
for working interface
!
Encapsulation PPP, LCP Open
Open: IPCP
!
For non working interface I am getting
!
Encapsulation PPP, LCP Closed
Base PPPoE vaccess
!
Can some one advice about the situation.
12-02-2016 06:03 AM
Hi,
On the FastEthernet interface have you entered the commands ppoe-enable and ppoe-client dial-pool-number X - where X is the same dialer-pool as being used on the Dialer2 interface?
Regards
Tom
12-02-2016 06:28 AM
HI Tom,
Thanks for input.
Yes I have entered following commands
pppoe enable group global
pppoe-client dial-pool-number 10
and match pool number with number on Dialer interface.
12-02-2016 06:29 AM
Hi,
have you put ip address negotiated on the dialer interface? Could you post the config?
Regards
Tom
12-02-2016 06:39 AM
hi
Please find config
sh run int dialer 2
Building configuration...
Current configuration : 460 bytes
!
interface Dialer2
description vDSL ISPnew connection
bandwidth 20000
ip address negotiated
no ip redirects
no ip proxy-arp
ip mtu 1400
ip nat outside
ip inspect CBAC-External out
no ip virtual-reassembly
encapsulation ppp
ip tcp adjust-mss 1360
no ip mroute-cache
dialer pool 10
dialer idle-timeout 900
dialer vpdn
dialer-group 10
no cdp enable
ppp chap hostname <verified and correct>
ppp chap password 7 <verified and correct >
end
Config of Fast Ethernet
sh run int fastEthernet 0/0/3
Building configuration...
Current configuration : 199 bytes
!
interface FastEthernet0/0/3
description vDSL secondary circuit 20Mbs/3Mbs
bandwidth 20000
duplex full
speed 100
pppoe enable group global
pppoe-client dial-pool-number 10
no cdp enable
end
12-02-2016 06:59 AM
Hi
Take out dialer vpdn from dialer interface config. Also do debug ppp negotiations and paste the output.
Cheers
Tom
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide