IOS Bundled Help

[KGrev]

Hi,

I'm sure this topic has been beat to death but i'm getting forgetful in my old age. I have an ISR 809 router running an older

ir800-universalk9.SPA.158-3.m2a firmware

and want to update it. The version i'd like to use is

ir800-universalk9-bundle.SPA.159-3.m7a.bin

but it is a bundled version like the rest of the versions offered on the downloads page. When I try to set this version to boot i get an error

exec format error

How do I get around this error. Is it because of the bundled IOS?

[marce1000 · Accepted solution]

 - Ref : https://www.cisco.com/c/en/us/td/docs/routers/IIoT/release-notes/15-9-3M7/15-9-3M7-Release-Note.html
 >...
   On the

IR8x9

devices, the

IR800 bundle

image can be copied via Trivial File Transfer Protocol (TFTP) or SCP to the IR800, and then installed using the

 bundle install flash:<image name> 

command. The

IR800 <image>.bin file

can NOT be directly booted using the

boot system flash:/image_name

Detailed instructions are found in the Cisco IR800 Integrated Services Router Software Configuration Guide .
                     Please follow these  procedures ; and check the link from the previous sentence too , 

 M.

[KGrev]

That helped, thank you.