KGrev
Participant
Participant
Member since ‎08-04-2021
Online

User Statistics

  • 243 Posts
  • 4 Solutions
  • 53 Helpful votes Given
  • 73 Helpful votes Received
Recent Badges
50 Replies
 30 Helpful Vote
20 Replies
1 Accepted Solution
10 Replies
10 Helpful Vote
5 Replies
1 Helpful Vote
FirstQuestion

User Activity

Hi,I have a Cisco IR809G. When it boots the cellular int 0 does not get an ip from At&t. However, when I shut/no shut the interface it will get an ip. Is there an event manager script to wait for it to get an ip then reload the cellular 0  if it does...
Hi, we recently changed the configuration and updated IOS on some IR809G routers we haven't used in a long time. Before any changes they would connect fine but after everything we did they will no longer automatically get an ip on its Cellular 0 inte...
Hi,I have a 4500X that is dropping ospf neighbors occasionally. This behavior just sort of started one day. It is dropping opsf to its 6 neighbors intermittently about 1 neighbor every few minutes. When I run debug on ospf I can see timers hitting. V...
Hi,I've been troubleshooting my way into a hole here.We have a few IR809G routers using EZVPN over cellular. They work fine but they are using ikev2. We are trying to upgrade them to ikev2. I see plenty of ways to enable ikev2 and configure it but we...
Hi, I'm sure this topic has been beat to death but i'm getting forgetful in my old age. I have an ISR 809 router running an older ir800-universalk9.SPA.158-3.m2a firmware and want to update it. The version i'd like to use is ir800-universalk9-bundle....
Community Statistics
Member Since ‎08-04-2021 07:59 AM
Date Last Visited ‎10-03-2023 01:09 PM
Posts 243
Total Helpful Votes Received 73