So I'm attempting to use the IOS to XE convertor tool, and having difficult time understanding the output results and why some lines are showing "Unprocessed" . I have like 191 lines showing "unprocessed" with pretty basic commands, that don't make sense to me, what is it trying to tell me.
Example:
Unchanged tunnel interface commands
335 interface Tunnel371
description Tunnel 371 (via DS3) to SP7NRTR01 (10.0.2.46)
ip address 10.0.x.x 255.255.255.252
ip mtu 1399
------------------------- Then remaining tunnel config show unprocessed...why?
I think it's trying to tell you what commands are not supported or outdated.
Unchanged tunnel interface commands
!ip flow ingress ------- this is old netflow, you should use flexible netflow not
vlan 30
--------------
ip vrf xx ******* now vrf forwarding name
rd 1:1
------
standby 1 check config guide for HSRP
---------
connection plar 2221111
---------
privilege exec level
-----------------
crypto map not sure is this is still a good pratice.
CCIE 52804
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: