01-13-2025 09:26 AM
so we recently upgraded to all cisco 9200 L2 switches and 9300s for our cores and we have been in testing with adding cameras and replacing cameras is where we stumbled onto an issue where when trying to replace a cameras with a different camera but the same IP address the switch would not allow the camera to be seen on our video monitoring software because the switch is still holding on to the former IP address
01-13-2025 09:32 AM
Only clear mac and arp table.
Or connect PC to subnet of camera and ping to broadcast of subnet, this force all camera to reply and update arp and Mac table
MHM
01-13-2025 09:35 AM - edited 01-13-2025 09:37 AM
Clear ARP in 9300 (if your L3 is configured there), it should work.
clear ip arp <camera ip>
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide