cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
519
Views
0
Helpful
1
Replies

IP inspect and 3640 router

adnane dakna
Level 1
Level 1

Hello ,

In my GNS3 lab i'm trying to setup IP inspect  in order to understand the functionnality of this command "ip inspect " , but  I cant' found the command under global config mode

my show ver of  is : 

Cisco IOS Software, 3600 Software (C3640-JK9S-M), Version 12.4(16), RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Wed 20-Jun-07 11:43 by prod_rel_team

ROM: ROMMON Emulation Microcode

ROM: 3600 Software (C3640-JK9S-M), Version 12.4(16), RELEASE SOFTWARE (fc1)

1 Accepted Solution

Accepted Solutions

cadet alain
VIP Alumni
VIP Alumni

Hi,

There is no firewall feature set in this image , you need an image with the FW feature set( with o3 in the name).

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

View solution in original post

1 Reply 1

cadet alain
VIP Alumni
VIP Alumni

Hi,

There is no firewall feature set in this image , you need an image with the FW feature set( with o3 in the name).

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
Review Cisco Networking for a $25 gift card